Table of Contents

A felt ornament is one of the few projects that can be finished in an evening and still be hanging on a tree twenty years later. It also shows every shortcut. Felt has no seam allowance to hide a wobbling stitch, no weave to absorb a knot pulled too tight, and no way to press a crooked edge back into line.

The skills are modest: two stitches, one template, and an order of operations that keeps the back almost as clean as the front. Most difficulty comes from the wrong felt or a thread pulled too hard.

This guide covers felt weight and fiber, thread and needle choice, three simple shapes, blanket and whip stitch, stuffing, hanging loops, and a finishing sequence that buries knots where no one can see them.

Why Felt Rewards a Different Set of Habits

Felt is a nonwoven fabric: fibers are matted and pressed into a dense sheet rather than woven. It does not fray, so a cut edge can stay raw, and it has no true grain line, so a small shape can be cut in any direction.

That makes it beginner-friendly and removes the usual places to hide an error. In woven cotton, a slightly uneven seam allowance disappears into the seam. In felt, the cut edge is the finished edge, so a wobbly cut remains visible for the life of the ornament. Stitch length is equally exposed. A blanket stitch that swings from 1/8 inch to 1/4 inch reads as a mistake rather than as character.

Felt also compresses. A tight stitch leaves a permanent dimple, and an overstuffed ornament shows gaping holes along the seam. Treat it like soft leather rather than quilting cotton.

Choosing Felt Weight and Fiber

Craft felt from a big-box store is usually acrylic, about 1 to 1.5 mm thick and sold in 9-by-12-inch sheets. It is inexpensive, comes in dozens of colors, and is fine for children's projects and short-lived ornaments. It also pills, shines where handled, and creases white along a fold.

Wool felt and wool-blend felt are denser. A blend with 20 to 35 percent wool costs more but takes stitches cleanly, holds a crease, and resists pilling. Pure wool felt at 1.5 mm is the sweet spot for ornaments in the 3-inch range: thick enough to hold a shape, thin enough to turn a small curve without puckering.

For ornaments 4 to 5 inches across, use 2 or 3 mm felt so the piece does not flop. For tiny 1.5-inch shapes, 1 mm keeps the ornament from looking like a pillow. A simple test: fold a corner and release it. Acrylic holds a sharp white crease; wool-blend springs back. If fibers lift when rubbed, the ornament will look worn by New Year.

Avoid adhesive-backed felt for sewing: the glue dulls needles and keeps the seam from sitting flat.

Thread, Needle, and a Knot You Can Hide

Embroidery floss is the default thread. Separate the six strands and use two or three for a 1.5 mm ornament. Three strands give a visible, slightly raised blanket stitch; two look finer and are easier to keep even. Perle cotton in size 8 is a good alternative because it does not separate and has a gentle twist that fills the stitch. Size 5 perle is too heavy for small shapes but works on 3 mm felt and on hanging loops.

Use a sharp size 7 or 8 embroidery needle for wool felt; it passes through dense fiber without a fight. A size 22 tapestry needle has a blunt tip and is safer for children. A guide to choosing embroidery thread helps when the project moves beyond basic floss.

Cut thread about 18 inches long. Longer thread tangles and abrades as it passes through the felt, which makes it look fuzzy by the last few stitches.

Start with a quilter's knot: wrap the thread twice around the needle, slide it down, and pull. Better, start between the layers so the knot is trapped inside. End the same way: knot between layers and bury the tail in the stuffing.

Three Shapes That Teach Everything

A circle, a star, and a mitten cover most of the skills needed for any ornament. The circle teaches even spacing on a curve. The star teaches corners and points. The mitten teaches an inside curve and a narrow opening.

Make templates from cardstock or a manila folder, not printer paper, which deforms after a few traces. Draw half the shape on a folded edge and cut once for symmetry. A five-point star can be drafted from a 3-inch circle at 72-degree intervals, but tracing a cookie cutter is faster.

Felt does not need a seam allowance for flat ornaments; cut exactly on the template line. For a stuffed ornament, add 1/8 inch all around so the finished piece reaches the intended size after it is filled. Trace on the back with a chalk pencil, a silver gel pen on dark felt, or a fine permanent marker in an area that will be hidden. Cut inside the line with sharp scissors. Dull scissors push the felt and produce a beveled edge that catches the light.

Cut two mirrored pieces if the felt has a brushed direction; wool felt often does, and two pieces cut the same way can look mismatched.

Blanket Stitch, Step by Step

Blanket stitch is the traditional edge finish for felt because it wraps the cut edge and creates a visible, even border. Work from right to left if you are right-handed.

Bring the needle up 1/8 inch from the edge and hold the thread down with your thumb. Insert the needle 3/16 inch to the right and 3/16 inch down, through both layers, and bring it up below the starting point with the loop under the needle point. Pull gently. The stitch should sit at a consistent depth and lie flat against the edge.

For 1.5 mm felt, 3/16-inch spacing and depth is a good starting point; for 3 mm felt, go to 1/4 inch. Smaller stitches look delicate but take three times as long and can perforate the felt into a tear. At a star point, place one stitch directly at the tip, then pivot the work and continue. At an inside corner, take a shorter stitch so the thread does not bridge the gap.

The common error is tension. A tight stitch makes the ornament cup and leaves a ridge along the seam. If the edge waves, the thread is too tight or the spacing too wide.

Whip Stitch When Speed Matters

Whip stitch is a straight stitch over the edge, worked from the same side, with each stitch crossing the seam at a slight angle. It is roughly twice as fast as blanket stitch and uses less thread. The trade-off is a less finished edge and a tendency to look uneven on tight curves.

Use whip stitch for small ornaments, classroom projects, and inside curves too tight for blanket stitch. Use blanket stitch for gift ornaments and anything handled every year; the difference is visible from a few feet away.

A useful hybrid is blanket stitch around the outside and whip stitch across the top, where the hanger hides the join. Whichever stitch you use, keep the depth the same on both sides; a stitch deep on the front and shallow on the back pulls the layers out of line.

Stuffing, Closing, and the Hanging Loop

Polyester fiberfill is standard. Tease a handful into a loose cloud rather than pulling a dense tuft; clumps read as lumps through felt. A 3-inch ornament takes 3 to 5 grams, about the volume of a golf ball.

Leave a 3/4- to 1-inch opening. Push the fill in with a chopstick, working toward the edges first and the center last. The ornament should feel firm but still give when pressed. Overstuffing spreads the stitches and opens gaps; understuffing lets the felt crease.

Close the opening with a ladder stitch: small horizontal stitches on each side, pulled to draw the edges together invisibly. On acrylic felt, a whip stitch is acceptable and faster.

Attach the loop before the seam is closed. Cut 3 inches of perle cotton or 1/4-inch ribbon, fold it, and insert the folded end 1/2 inch between the layers at the top center. Stitch through it twice with doubled thread, then continue the seam. A 2- to 2.5-inch loop hangs well; longer loops make the ornament sit low. A bead at the base hides the join.

A Finishing Order That Hides Knots

The order matters more than the individual stitches:

  1. Cut both layers and mark the front.
  2. Embroider the front flat, before assembly, with knots buried between the layers or under the design.
  3. Attach beads last, after embroidery, so the needle does not catch them.
  4. Pin the loop at the top center and baste it if the felt is slippery.
  5. Stitch from the top clockwise, leaving the opening at the bottom.
  6. Stuff through the opening, then close it.
  7. Bury the final knot between the layers, run the thread through the stuffing, and trim close.

Working flat is the biggest improvement: tension is easier to keep on one layer, and small errors sit against a flat surface rather than a curve. Beads added after assembly also pull the stuffing out of shape.

If a knot must sit on the back, cover it with a small felt circle or a tiny cross stitch. A beginner's guide to essential sewing techniques covers the ladder stitch and other hand-sewing fundamentals used here.

Batch Production and Storage

Felt ornaments are ideal batch projects. Cut 12 to 24 pairs at once and work one step at a time: all fronts embroidered, all loops pinned, all seams started. After the first three, a 3-inch ornament takes 15 to 20 minutes.

Store finished ornaments flat in a shallow box with acid-free tissue. A plastic bag traps moisture and crushes loops; a cedar block keeps moths away from wool. Keep the box out of direct sun. The same care that applies to storing finished holiday crafts applies here.

The Decision Rule

Choose the material by purpose. For a keepsake or a gift, use wool-blend or wool felt at 1.5 mm, three strands of floss, and blanket stitch. For a classroom, a toddler table, or a large batch for a swap, use acrylic felt, two strands, and whip stitch.

Whatever the material, make one complete ornament before cutting twenty. It answers what a template cannot: whether the shape is too small to turn, whether stuffing shows, and whether the loop balances the piece. One test piece costs fifteen minutes; a bad batch costs an evening.

Keep the first ornament even if it is imperfect. It becomes the reference for tension, spacing, and stuffing volume.

Frequently Asked Questions

What thickness of felt is best for ornaments?

Use 1.5 mm felt for ornaments around 3 inches across, 2 to 3 mm for larger shapes that need to hold their form, and 1 mm for tiny pieces. Wool or wool-blend felt at those weights takes stitches more cleanly than acrylic and resists pilling.

Can I sew felt ornaments by hand without a machine?

Yes. Blanket stitch or whip stitch around the edge is the entire construction, and both are hand stitches. A 3-inch ornament takes about 15 to 20 minutes once you have practiced the stitch on a scrap.

How much stuffing goes into a small felt ornament?

A 3-inch ornament needs roughly 3 to 5 grams of teased polyester fiberfill, about the volume of a golf ball. Add it in small wisps and stop when the ornament feels firm but still gives when pressed.

What is the difference between blanket stitch and whip stitch?

Blanket stitch wraps the cut edge with a consistent looped border and looks more finished. Whip stitch crosses the edge with simple straight stitches, is faster, and works better on tight inside curves and children's projects.

See Also